Or this guy on the bottom port mandible?
An RPF Open Source 5 ft Millennium Falcon Build/Reference Thread. All Are Welcome
- Thread starter jcoffman99
- Start date
Mauretania cut down. Thank manugu
You certainly have my appreciation while I too am on the right side of the earth. Many hours & days of help.
We're having a bit of a discussion over on Kitbash about this: This is from the ESB pits which we know recycled bits of the ANH pits. Think this was original? If so, I need to change the car part.
Looks like Tiffany is making model tank parts now. Lol
Corrected a mistake on the engine deck maps regarding the Centurion screw driver. I had the wrong number. It has been corrected and uploaded to my drive.
If one spots this detail analogy so quickly it really means something: “Resistance is futile”
Wow. That is impressive sleuthing. Well done. Been looking at Sealab parts for 8 years now and never saw that.
Manugu gets all the credit.
manugu
Well-Known Member
Thanks, in the end it was a community effortManugu gets all the credit.
Updated the engine deck maps again to label the Centurion part attached to the 7.5mm tank gun part and removed the highlighting of the t-track next to the Sealab parts.
Also updated the port mandible bottom to reflect the newly discovered Sealab piece and the ventral rear close map
Also updated the port mandible bottom to reflect the newly discovered Sealab piece and the ventral rear close map
Last edited:
Hi there.
Would it be possible to get a clarification of this part;
The little gear is tagged as part N45 from the Hummel (61). But when I compare that part to the photos, it doesn't seem to match. And, as near as I can tell, it doesn't have the correct diameter. It also seems to be missing the taper.
Can we confirm that N45 is the correct part?
thanks
Would it be possible to get a clarification of this part;
The little gear is tagged as part N45 from the Hummel (61). But when I compare that part to the photos, it doesn't seem to match. And, as near as I can tell, it doesn't have the correct diameter. It also seems to be missing the taper.
Can we confirm that N45 is the correct part?
thanks
That isn't the right part. I haven't found the right one yet.
I'm wondering if it might be one of the brass gears that come with the RC tanks? I've never really looked closely at those before.
Maybe one of these? I can check in the morning.
It's possible. I'll have a poke around.
thanks
thanks
I've gone through the motorized amour and ship kits that I have access to used for this build. All the pinion gears are ~7mm, we are looking for 11mm. (determined by scaling up the Bandai PG kit gear)
If it is a real gear (it sort of looks it), it could be just a found part from anything they had laying around, and not from a kit at all.
For kicks, I popped open a couple of RC servos to have a look. Nothing useful.
[edit] This morning I rummaged through the racing car kits, the kettlegrad, the BMW motorcycle, the Tamiya racing bike, the big M60, and a few additional smaller kits. No joy.
If it is a real gear (it sort of looks it), it could be just a found part from anything they had laying around, and not from a kit at all.
For kicks, I popped open a couple of RC servos to have a look. Nothing useful.
[edit] This morning I rummaged through the racing car kits, the kettlegrad, the BMW motorcycle, the Tamiya racing bike, the big M60, and a few additional smaller kits. No joy.
Last edited:
Could it be one of those Aavid Thermalloy 323005B00000G heatsinks used on X-Wings?
Those would be too big I'd think.
