OasisSupernova
Sr Member
It's my bottom trim panels that don't line up. Not that I care. I can trim them to make them fit. Honestly I wouldn't know the right size of this Ark if it swam up and bit me in the ass. Lol
I've released my Ark of the Covenant 3d Files
- Thread starter Rebelscum
- Start date
IceDog
New Member
Better that than melting your face
I hadn't checked this thread in a few weeks, had a lot of catching up to do, and now there are more peeps building!
OasisSupernova
Sr Member
LolBetter that than melting your face
OasisSupernova
Sr Member
Sure does. Looks good!
Thank you--1 down- 1 million to go
OasisSupernova
Sr Member
LMFAOThank you--1 down- 1 million to go
This page explains measurements in great detail-- Might explain your pieces not lining up. --still guessing this is what we should be referencing
Building an Ark of the Covenant from our kit
Philip Wise here to show how to use our Ark kits to build an Ark of the Covenant, just like the one I finished years ago. The kit has been posted in the classified section. Since we had a couple assembly commissions waiting on the kits, we used that first one to document the process so I could...
www.therpf.com
OasisSupernova
Sr Member
Do you mean the grey board? The 3/4 MDF?
Attachments
turn on layer compensation before you end up sanding for 10 years
OasisSupernova
Sr Member
I played it on a flat table. Put the lid on it upside down and used my finish nailer and shot nails between the leaves. Lol
Where's that setting?
I tried adjusting my prints to the speeds and settings you showed me; however, I started getting strings and bumps unlike I ever had. I went back to normal settings it the prints went back to the consistency I had before. Slow but good. I cant really see the settings you have on that screen grab. Too small and they blur when I go full screen. I did try the best I could. The slicer time added 4 hours to the print. Does that sound right?
I'm using a Neptune 3. Not sure if that makes a difference or not.
unfortunatly its the pom wheels. I upgraded to rails. Go at maybe 50-75 mms
I'm at 60 right now. Factory setting I think-Taking me 14 hours to print the upper leaves corners per unit
If it were me, id upgrade to a core xy printer that can do 500mms. Mine took nearly 3 weeks to print everything at 250mms on my N4M. If its not in the cards to upgrade the printer, then you do what you gotta do. It took my N4M with rails 6 hours for that part
