Sean
Master Member
with the precision and exacting standards you go by Joe. you guys don't want to miss out on this
Last edited:
-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Done / Completed Blade Runner 2049 K's Blaster w accurate prop function
- Thread starter JOATRASH FX
- Start date
-
- Tags
- blade runner
with the precision and exacting standards you go by Joe. you guys don't want to miss out on this
Five kits still (amazingly) unaccounted for and printing is in full swing...
Funds sent! :cheers
Check the first post for photos of my (almost finished) buildup of this kit.
Interested!
Heya!
I sent you a PM with payment instructions in case you want one. Since this is now a run and not an interest list, I am not taking down a list any longer and am assigning slots on a first-come basis.
One that note.... I'm down to the last couple of free slots on this. If there are any left once they start shipping, I'll put them in the junkyard but the cost will most likely go up.
Just updating everyone that printing parts is progressing. Most of the larger pieces are done. Having a wee bit of trouble mass-printing the smaller pieces with consistent quality, so I've had to break it down a little, printing in smaller batches, which takes a lot longer. But no road blocks in sight at present!
If anyone else wants one of these, I might have a spot left.
If anyone else wants one of these, I might have a spot left.
Just did a count and it seems I do still have a couple spots left. This run will not be repeated.
Everyone gets a unique serial number!
Thanks. I hope you got a coat you'll be happy with. (I wore my Zlurpo copy almost every day this past winter!)
Going to do a tally of all the parts I have at the beginning of next week and will try to post of photo of what it all looks like. Right now I think I'm down to 1-2 spots left (and I might keep one of those in reserve, just in case.) Still printing out a lot of the smaller parts.
I’ve been meaning to get a photo of all the parts so far. On the home stretch but we have an ongoing heat wave here, 30+ degrees celsius indoors some days, and high humidity so I haven’t ben able to get optimum results while printing. Supposed to cool down next week, so maybe I can start finishing up then. I’d really want to have these all shipped by September!
Any spots left at all? 100% on board if there's any left
There is ONE unclaimed spot left.
Oslo
New Member
Count me in please, I'll drop you a pm
