Small update. I'm doing more test prints this weekend. The model is more or less finished, I'm just fine-tuning details, size and fit. (Every time I change something I have to redo all the cutouts for the electronics, lol.) I'm on the home stretch though. Have started looking at sourcing a supply of solenoids (Getting a supply of 10-20 pieces of the exact is a bit of a challenge, since I'd rather not get them from China but either a US or European seller.) I will probably do these in runs of 10 MAX, and stop at 20... maybe... each copy will take long to print because I'm going for a quality level that I haven't done before (the trigger guard alone takes 14 hours) , so I can't promise a run of more than ten. We'll see where the final print time lands at. I'm also looking at maybe doing offering custom serial numbers for them for an extra cost.