ricbret
New Member
I'm an occasional lurker and a definite admirer of your work. Please do clue me in if you ever decide to make another run of these, it's lovely.
Foundation Prime Radiant
- Thread starter renaissance_man
- Start date
There's potential for another few to be made for those who have expressed an interest.
I will post here and in the Junkyard thread when they are ready.
Thanks for your patience, it's been a struggle getting the laser cut parts together, the company does good work but are very unreliable with communication.
I will post here and in the Junkyard thread when they are ready.
Thanks for your patience, it's been a struggle getting the laser cut parts together, the company does good work but are very unreliable with communication.
Thanks for the offer, I will update the Junkyard thread when I have a couple finished and ready to go. I will be taking my time and trying to get each one as perfect as possible. After the struggle with air pockets previously in the run I'm going to slow down a bit, especially as each finished Prime Radiant requires manual, hand sanding of a bevel into 48 edges. It takes a toll on the joints.
Saul de Boer
New Member
I too would like to know if and when you'll be putting out Prime Radiants again. I admire your work and with the 3th season streaming again my hunger to have one for my desk grew again.
I'm hoping to get some laser cut tiles this week and the 3D printed lattices next week.
These are tricky props to get right so I won't buy rushing
I've ordered enough to make about 10 Prime Radiants.
I will reach out to people who have expressed an interest when a new Radiant is finished and ready to sell.
Thanks for your interest.
