don't worry about postage,if you would like to watch it pm me your address details and you can have it.Thanks buddy! I think postage would be more than just buying it on Prime though
don't worry about postage,if you would like to watch it pm me your address details and you can have it.Thanks buddy! I think postage would be more than just buying it on Prime though
don't worry about postage,if you would like to watch it pm me your address details and you can have it.
you've got me there jintosh. no idea what that is and i am fully awake mate.
Awesome! I was able to isolate the picture from the intro (split seconds are hard to catch on A running video) but it had words across it. I was able to catch room 9 and break down the image and re-insert the number into the outline of the sun.Hmm.....I found one pic in my collection. Hope you can clean it up enough to help.
This pic was not available to the public. I got it from the prop master from the show well after the show was over.
Awesome!
Just throwing this out there: I’ve been a fan of this show since I discovered it in 2010–still a bit crazy for it, it ebbs and flows.
Wow, I haven't really thought about props from The Lost Room in a long time! I used to be a member of The Collectors website as you were Jintosh. I just checked the collectors site and it's still alive but the traffic is pretty slow now. It even has a photo of my small collection at the time that still loads. Do you have any keys left Jintosh? I never got around to buying one back then. Blast from the past
Thanks!
Randy in San Diego
My key provider stopped responding to emails. I have not found a new one. Shapeways is way to expensive. I thought of casting them myself, but that has not become a reality yet. The keys are in Limbo.
Since it's been another year, have you had any luck sourcing the keys again? Got the key fob, but I still need the key to go with it.
If you have a key to copy, why not have actual keys cut at a local hardware store??
No, I am thinking I need to run down my website. You can get a one-off print of the key from Shapeways, but it'll be expensive.
You mean there's a file on Shapeways for printing the key? Or do I need to find the file elsewhere?
I seem to recall an older thread you posted regarding the key specifically, you'd mentioned maybe getting yours molded and cast?