-
-
AFor your consideration: 1. four mount points instead of 2 2. panel set back an additional 1mm
-
AAnnnddd... rewind. I've kept the other updates but reverted the flat bottom. While it's still 'untidy' on the print bed (at least...
-
AAnnd. opps. I forgot to re-add the cuts to the front, which I've also made deeper. In this one, I've falattened it in case any one is...
-
Aexcellent! I've just added a bit of padding to the internal, to hopefully make those side cuts look a bit better. You can still see some...
-
AHere's some fixed STLs, along with fixed mounting points (there was some swarf). 10% reduction in size.
-
AATDI reacted to scornflake's post in the thread I'm bored :) Suggest something for me to model, and watch me weep with
Like.
I added clips for the front panel, and also offset the panel into the body of the case by 2mm or so.
-
-
Loading…
-
Loading…
- Location
- Kentucky